oil and gas safety acronyms

rush to reach hard-to-reach areas. After covering the jewelry, place it on a clean dish or towel. 5 Rinse off the silver with warm wate r, starting with the first piece of jewelry that you started cleaning. Use a brush to remove any residue from crevices. 6 Dry the jewel ry completely after rinsing it to ensure that spotting does not appear. 7 Clean the most tarnished pieces of jewelry using a solution o f 1 part baking soda, 1 part salt, 1 part liquid dish soap and 64 parts water. Line a pot with aluminum foil, then add all the componen blog templates fantasy ts and mix them with a plastic spoon. 8 Put the pieces of silver jewelry into the pot and place the pot on the stove, with the heat tur ned on low. Bring the pot to a boil, and then remove it from the heat. Let the pot sit for 4 to 6 minutes. 9 Drain the mixture with a s oil and gas safety acronyms trainer and rinse the jewelry off with warm water. Dry all the jewelry using a soft, clean towel.1 Examine the bracelet clasp to see ho .

clasp. If you don't have a pair of pliers, use a heavy object such as a paperweight. 3 Replace the clasp if you cannot easily tighten i t. You can buy various clasps from jewelers or craft shops for as little as a few dollars. 4 Remove the broken clasp by prying open the jump ring, a thin circle of metal that connects the clasp to the bracelet. You will need two sets of smaller pliers to do this. Swap t he broken clasp for your replacement, then tighten the jump ring as indicated in Step 1. 5 If necessary, repeat this step on the other housekeeping invoice template free side of the bracelet.Leather Bracelet 1 Find a piece of scrap leather measuring between 1 and 3 inches in width. Scrap leather can be p urchased from a craft store or taken from an old belt or piece of furniture. 2 Cut the piece of scrap leather to fit your wrist comfort oil and gas safety acronyms ably. Wrap the piece of leather around your wrist. Leave an additional 2 inches of leather for the string that will hold your bracelet .

ie a double knot at one end of the piece of string. Insert the other end into the first drilled hole and then into the second drilled h ole. Tie another double knot. 5 Attach a decorative charm, clasp, beads or metal-plated pendant to the front center of the leather brac elet. Stars, skulls, crossbones and spiders are popular icons found on punk jewelry. Studded Bracelet 6 Cut a piece of foam sheet to fi t around your wrist. Measure the piece of foam to be approximately 1 inch longer than the circumference of your wrist to allow room for 3d model of n the snap fasteners. 7 Design a pattern made out of pyramid studs or spikes. Both come in a variety of sizes and colors. Decide if you would like to cover the entire outside surface of the bracelet with the studs or spikes or just a line down the length of the foam. 8 P oil and gas safety acronyms oke the studs or spikes into the foam. The backs of the studs and spikes contain a sharp set of pins that will push through the soft fo .


oil and gas safety alerts 2012 | oil and gas safety acronyms | oil & gas safety training online | gas safety service